1-28. “Auto Off Time(TX)”: This function is only available when the
“YES” mode of “Continuous(TX)” is
selected.
a. The transmitter will power off itself after a
given idle time for saving Transmitter’s battery
power.
b. Whether the transmitter will send the signal to
power off the MAIN relay in the receiver or not,
that would be verified by the function of “Auto
Off(EMS) set on “YES” or “NO”.
1-29. “Auto Off(EMS)”: “YES” or “NO”.
a. “YES”: The transmitter will send the signal to power
off the MAIN relay in the receiver after a
given idle time. To power on again
according to “Power On Mode”.
b. “NO”: The transmitter will not send the signal to
power off the receiver after a given idle time.
1-30. “LED On/Off”: “YES” or “NO”.
a. “YES”: The transmitter’s green LED glows
according to “LED Off Time” when
transmitting. If a warning such as an
insufficient battery power occurs, the
transmitter’s red LED will glows at the first
priority.
19
To Next Page
Loading...
