b. “NO”: The transmitter’s green LED won’t glow
when transmitting. But the transmitter’s red
LED will glow if an warning occurs.
1-31. “LED Off Time”: This function is only available when the “YES”
mode of “LED On/Off” is selected. The interval
time can be selected from 0 ~ 4 seconds and the
LED glowing time is fixed at 0.4 second a time.
1-32. “READ R/C”: Read the data from transmitter or receiver on PC or
Laptop for verifying or renewing.
4-33. “WRITE R/C”: Write the data set to the transmitter or receiver.
1-34. “Model”: Display model number after reading the data.
1-35. “ID Code”: Display ID Code after reading the data which is an
unique code for each Remote Control, both transmitter
and receiver won’t work if they have different ID codes.
20
To Next Page
