To Next PageTo Next Page
Need help?Do you have a question about the Teledyne STREAMPRO and is the answer not in the manual?
General| Manufacturer | Teledyne |
|---|---|
| Velocity Resolution | 0.1 cm/s |
| Power Supply | 9-36 VDC |
| Communication | RS-232, RS-422, Ethernet (optional) |
| Operating Temperature | -5°C to +45°C |
| Storage Temperature | -30°C to +60°C |
| Flow Range | N/A (ADCP measures velocity profiles, not direct flow rate) |
| Accuracy | N/A (Flow Range is N/A) |
| Output | Velocity profiles, water depth, signal amplitude, correlation magnitude, instrument tilt |
| Material | Hard Anodized Aluminum or Stainless Steel (depending on model) |
| Protection Rating | IP68 |
General introduction to the StreamPro ADCP system, its components, and features.
Lists the components included with the StreamPro system and its accessories.
Description of optional platforms like the Riverboat SP and Q/Z 1250 Power Trimaran.
Overview of the StreamPro ADCP assembly process.
Overview of maintenance guidelines for the StreamPro ADCP.
Instructions for mounting the electronics housing to the tethered trimaran.
Steps for attaching and removing the solar shield from the electronics housing.
Instructions for attaching the boom to the tethered trimaran and connecting the transducer cable.
Guidance on adjusting the transducer angle and depth for optimal performance.
Steps for adjusting the angle of the towing harness.
Instructions for properly storing the StreamPro ADCP in its shipping crate.
Lists components included in the spare parts kit for the StreamPro ADCP.
Step-by-step guide for replacing the AA batteries in the StreamPro ADCP.
Recommendations for regular inspection, upkeep, and calibration schedules.
Criteria and procedures for visually inspecting the StreamPro for damage or wear.
Steps to clean biofouling and replace O-rings for maintaining integrity.
Steps for replacing the locking ring on the transducer cable connector.
Guidelines for packing and shipping the StreamPro ADCP for repair or upgrade.
Process for obtaining RMA and shipping instructions for TRDI factory returns.
Instructions for returning systems to the TRDI Europe facility for service.
Explains communication, command input, and data output formats.
Commands for managing system parameters and environmental settings.
Commands for sensor source selection and water profiling parameters.
Commands for fault logging, performance testing, and built-in diagnostics.
Introduction to PD0 format, data types, IDs, and buffer structure.
Details on Header, Fixed Leader, and Variable Leader data formats.
Formats for Velocity, Correlation, Echo Intensity, and Percent-Good data.
Formats for Bottom-Track, StreamPro Leader, and matrix data.
Technical specifications for velocity profiling and long range modes.
Specifications for transducer, sensors, compass, and communications.
Environmental, power, and physical properties specifications.
Provides installation drawings for the StreamPro ADCP.
Lists components and initial steps for assembling the Riverboat SP-C.
Instructions for attaching the transducer, crossbar, and hull components.
Instructions for assembling the bridle, outriggers, strap handles, drag fins, and electronics case.
Lists components and initial steps for the GPS mounting kit.
Steps for attaching the sunshield and non-magnetic antenna base.
Steps for installing the transducer, GPS arm, and connecting the antenna.
Information on date of manufacture and environmental friendly use period.
Compliance information regarding waste electrical equipment and EMC.
Table disclosing toxic or hazardous substances in product components.
