Operating the CD player
20
Using the programming function
You can use the programming function to play up to 20
tracks from a music CD or 99 tracks from a MP3/WMA
CD in a sequence that you specify. With MP3/WMA CDs,
always programme the album first and then the track.
Note:
You can only use the programme function if a disc is
located in the closed CD compartment (7) and the Stop
mode is activated.
Î Insert a CD into the compartment (7) and close the
lid.
Î Press the button (11).
Î Press the PROGRAM button (12).
The number in the programme sequence P-01 and
"PROG" appear on the display (17), the track number
"001" flashes for audio CDs, the album number "01"
flashes for MP3/WMA CDs.
Î Select the album for MP3/WMA CDs with IWW (2) or
XXI (3) and confirm your entry with PROGRAM
(12). The track number "001" flashes.
Î Select the first track to be programmed using IWW
(2) or XXI (3). With an MP3 CD you can advance
10 tracks using +10/ALBUM (13).
Î Save the desired track number using the
PROGRAM (12) button. The track is now
programmed at location 01.
Î The number of the next memory location now
appears in the display (17). Programme the desired
order of the tracks in the same way.
Î Press the X II button (4) to start playback of your
selection. PROG and the current track number
appear in the display (17). With MP3/WMA CDs, the
indicator displays the album number and the track
number.
Î If you want to interrupt playback of the programmed
selection, press the X II button (4) once.
Î To resume playback press the X II button (4) once.
Î To stop playback of the programme press the
button (11).
Note:
When you open the CD compartment (7) or actuate the
FUNCTION switch (20) the programme memory is
deleted. Pressing the button (11) twice also ends the
programme function.
To Next Page
Loading...
