Teleorigin RB900SG-E5 - Modem Text Command Reference

23
Text commands
Below is a list of the available RB900SG modem text commands. All below commands are
available from 2.2.x modem firmware version. They can be send over USB, SMS or
Teleorigin Manager.
Special characters:
<EXT> - End of Text 0x03 character
<CR> - Carriege Return 0x0D character
<LF> - Line Feed 0x0A character
NOTE: <CR><LF> characters can be omitted when the command is sent via SMS and
Teleorigin Manager („Console” tab).
1. Device commands
RB900SG Commands
RB900SG GET FW VERSION<CR><LF>
Downloads the firmware version number of
the microcontroller
Response
x.x.x<CR><LF>
where x – version number
Response example
2.2.2<CR><LF>
RB900SG GET IP<CR><LF>
Retrieves the IP address of the device
Response
x.x.x.x<CR><LF>
Response example
10.43.210.2<CR><LF>
RB900SG GET RTCTIME<CR><LF>
Gets device time in Unix time or unless the
clock is out of sync then rtc time is equal
uptime
Response
xxxx<CR><LF>
Response example
868<CR><LF>