Teletek electronics SIMPO - Operation Modes; Review of Alarm Events; Review of Fault Events

SIMPO - BASIC INFORMATION
Page 6 of 48
Simpo Addressable Panel
2.) Programming
2.1) Front Panel Description
2.1.1) Access codes
To access the Programming and Maintenance Menus it is necessary to enter a
valid access code. There are 3 access codes programmed by default:
- USER Access – no code needed
- Maintenance Access code
- Installer Access code
Access code length is maximum 4 digits.
Introducing the codes is by means of the special number buttons on the front panel:
Access codes table
Code type
Code combination
Access
level
Functions
User
-
1
Only Silence Buzzer and
Evacuation (If there is a fire
alarm active – it will be for
removing of the active delays
of Sirens output, Fire Output,
Addressable Sounders and
MOUT modules) buttons are
active. It is not allowed to enter
the Programming and
Maintenance Menus.
Maintenance
2222
2
Silence Buzzer, Silence Alarm,
Reset and Evacuate buttons
are active. It is allowed to
enter only the Maintenance
Menus. Also the extinguishing
module buttons for disabling
are active.
Installer
3333
3
Silence Buzzer, Silence Alarm,
Reset and Evacuate buttons
are active. It is allowed to
enter both the Programming
and Maintenance Menus. Also
the extinguishing module
buttons are active.
The entered code combination is confirmed by pressing the Enter button. You can
delete the entered digits by pressing the Enter button again. Exit from the access level is by
pressing the Esc button.