19
EN
Through this menu you will be able to make the ZAS HD
SAT record an event at a programmed time. Up to 20
di erent events can be programmed.
The list is displayed empty if no event is created.
This function is only possible if you have an
external drive formatted with FAT 32, a pen
drive (memory stick) or a memory card reader.
Create/Add an event
keys or and press OK to con rm.
To add a new event, press the OK key over the option
Timer on the Main Menu.
Select one of the timers with the cursor
or keys
and press OK to con rm.
Channel: Indicate the channel to be recorded once the
receiver is turned on. By default, it displays the current
channel. Select another one with the keys or .
Date: Enter the date for the event.
Starting Time: Enter the starting time for recording.
Ending Time: Enter the time o for recording
Repeat: Indicate whether this process is performed only
once (“No Repeat”), “Everyday” or “Every week.”
Finally, press OK on the remote control unit o activate the
timer.
Delete an event
A list of programmed events will appear on the “Timer”
menu in both manual format as well as through the EPG.
See par. 7. Electronic Program Guide (EPG).
To delete an existing event, position the cursor over the
EPG and press the red key.
- The time shown on the adapter is sent by the
service provider. Very rarely, it might happen
that this time is not correct. Check this before
programming an event.
- During the procedure of a Timer only programmes
of the same Multiplex can be seen.
- Events cannot be created if the start or end times
are lower than the current ones.
- Events cannot be created if the time overlaps.
10. Timers
To Next Page
Loading...
Need help?
General
