HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 101 of
229
+CGEQREQ – 3G Quality Of Service Profile (Requested)
64 kbps steps), (0,1-63 in 1 kbps steps, 64-568 in 8 kbps steps, 576-8640 in 64 kbps
steps, 8700-16000 in 100 kbps steps),
(0,1-63 in 1 kbps steps, 64-568 in 8 kbps steps,
576-8640 in 64 kbps steps),
(0,1-63 in 1 kbps steps, 64-568 in 8 kbps steps, 576-8640
in 64 kbps steps, 8700-16000 in 100 kbps steps),
(0-2), (0,10-1500,1502,1510,1520),
("1E6","1E5","1E4","1E3","7E3","1E2","1E1",","0E0"),("6E8","1E6","1E5","1E4","
5E3","4E3","1E3","5E2","1E2","0E0"),(0-3),(0,10-150 in 10 ms steps, 200-950 in 50
ms steps, 1000-4000 in 50 ms steps),(0-3)
OK
Reference 3GPP TS 27.007; 3GPP TS 03.60/23.060; 3GPP TS 24.008
3.5.3.7.10. PDP Context Activate Or Deactivate - +CGACT
+CGACT - PDP Context Activate Or Deactivate
AT+CGACT=
[<state>[,<cid>
[,<cid>[,…]]]]
Execution command is used to activate or deactivate the specified PDP context(s)
Parameters:
<state> - indicates the state of PDP context activation
0 - deactivated
1 - activated
<cid> - a numeric parameter which specifies a particular PDP context definition
(see +CGDCONT command)
Note: if no <cid>s are specified the activation/deactivation form of the command
activates/deactivates all defined contexts.
AT+CGACT?
Read command returns the current activation state for all the defined PDP contexts
in the format:
+CGACT: <cid>,<state>[<CR><LF>+CGACT: <cid>,<state>[…]]
AT+CGACT=?
Test command reports information on the supported PDP context activation states
parameters in the format:
+CGACT: (0,1)
Example AT+CGACT=1,1
OK
AT+CGACT?
+CGACT: 1,1
OK
Reference 3GPP TS 27.007
3.5.3.7.11. Show PDP Address - +CGPADDR
+CGPADDR - Show PDP Address
AT+CGPADDR=
[<cid>[,<cid>
[,…]]]
Execution command returns a list of PDP addresses for the specified context
identifiers in the format:
To Next Page
Loading...
Need help?
General
