HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 130 of
229
+CMGW - Write Message To Memory
Reference 3GPP TS 27.005
Example AT+CMGF=0 set PDU mode
OK
AT+CMGW=18
> 088128010099010259115507811020905512F90000A704F4F29C0E
+CMGW: 29
OK
AT+CMGF=1 set text mode
OK
AT+CSMP=17,167,0,0
OK
AT+CSCA=”821029190903”,145
OK
AT+CMGW="0165872928"
> test message...
+CMGW: 28
3.5.4.4.4. Delete Message - +CMGD
+CMGD - Delete Message
AT+CMGD=
<index>
[,<delflag>]
Execution command deletes message from preferred message storage <mem1>
location <index>.
Parameter:
<index> - message index in the selected storage <mem1>
<delflag> - an integer indicating multiple message deletion request.
0 (or omitted) - delete message specified in <index>
1 - delete all read messages from <mem1> storage, leaving unread messages and
stored mobile originated messages (whether sent or not) untouched
2 - delete all read messages from <mem1> storage and sent mobile originated
messages, leaving unread messages and unsent mobile originated messages
untouched
3 - delete all read messages from <mem1> storage, sent and unsent mobile
originated messages, leaving unread messages untouched
4 - delete all messages from <mem1> storage.
Note: if <delflag> is present and not set to 0 then <index> is ignored and ME shall
follow the rules for <delflag> shown above.
AT+CMGD=?
Test command shows the valid memory locations and optionally the supported
values of <delflag>.
+CMGD: (supported <index>s list)[,(supported <delflag>s list)]
To Next Page
Loading...
Need help?
General
