HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 35 of 229
E - Command Echo
Note: if parameter is omitted, the command has the same behaviour of ATE0
Reference V25ter
3.5.2.2.2. Quiet Result Codes - Q
Q - Quiet Result Codes
ATQ[<n>]
Set command enables or disables the result codes.
Parameter:
<n>
0 - enables result codes (factory default)
1 - disables result codes
2 - disables result codes (only for backward compatibility)
Note: After issuing either ATQ1 or ATQ2 every information text transmitted in
response to commands is not affected
Note: if parameter is omitted, the command has the same behaviour of ATQ0
Example
After issuing ATQ1 or ATQ2
AT+CGACT=?
+CGACT: (0-1) nothing is appended to the response
Reference V25ter
3.5.2.2.3. Response Format - V
V - Response Format
ATV[<n>]
Set command determines the contents of the header and trailer transmitted with
result codes and information responses. It also determines if result codes are
transmitted in a numeric form or an alphanumeric form (see [§3.2.3 Information
Responses And Result Codes] for the table of result codes).
Parameter:
<n>
0 - limited headers and trailers and numeric format of result codes
information responses
<text><CR><LF>
result codes
<numeric code><CR>
1 - full headers and trailers and verbose format of result codes (factory default)
To Next Page
Loading...
Need help?
General
