HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 37 of 229
3.5.2.2.4. Extended Result Codes - X
X - Extended Result Codes
ATX[<n>]
Set command selects the result code messages subset used by the modem to inform
the DTE of the result of the commands.
Parameter:
<n>
0 - send only OK, CONNECT, RING, NO CARRIER, ERROR, NO
ANSWER results. Busy tones reporting is disabled.
1..4 - reports all messages (factory default is 1).
Note: If parameter is omitted, the command has the same behaviour of ATX0
Note: Current value is returned by AT&V
Parameter:
<n>
0 - EXTENDED MESSAGES : X0=NO
1..4 - EXTENDED MESSAGES : X1=YES
Note For complete control on CONNECT response message see also +DR command.
Reference V25ter
To Next Page
Loading...
Need help?
General
