HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 88 of 229
3.5.3.4.22. Delete Alarm - +CALD
+CALD - Delete Alarm
AT+CALD=<n>
Execution command deletes an alarm in the ME
Parameter:
<n> - alarm index
0
AT+CALD=?
Test command reports the range of supported values for <n> parameter.
Reference 3G TS 27.007
3.5.3.5. Mobile Equipment Errors
3.5.3.5.1. Report Mobile Equipment Error - +CMEE
+CMEE - Report Mobile Equipment Error
AT+CMEE=[<n>]
Set command enables/disables the report of result code:
+CME ERROR: <err>
as an indication of an error relating to the +Cxxx commands issued.
When enabled, device related errors cause the +CME ERROR: <err> final result
code instead of the default ERROR final result code. ERROR is anyway returned
normally when the error message is related to syntax, invalid parameters, or DTE
functionality.
Parameter:
<n> - enable flag
0 - disable +CME ERROR:<err> reports, use only ERROR report.
1 - enable +CME ERROR:<err> reports, with <err> in numeric format
2 - enable +CME ERROR: <err> reports, with <err> in verbose format
AT+CMEE?
Read command returns the current value of subparameter <n>:
+CMEE: <n>
AT+CMEE=?
Test command returns the range of values for subparameter <n>
Note +CMEE has no effect on the final result code +CMS
Reference 3GPP TS 27.007
3.5.3.6. Voice Control
3.5.3.6.1. DTMF Tones Transmission - +VTS
+VTS - DTMF Tones Transmission
AT+VTS=
<dtmf>
[,duration]
Execution command allows the transmission of DTMF tones.
Parameters:
<dtmf> - a single ASCII character in the set (0 9), #,*,(A D); with a duration that
To Next Page
Loading...
Need help?
General
