HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 91 of 229
+CGEREP - GPRS Event Reporting
to the TE when <mode> 1 or 2 is entered (OK response shall be given before
flushing the codes)
AT+CGEREP?
Read command returns the current <mode> and <bfr> settings, in the
format:
+CGEREP: <mode>,<bfr>
AT+CGEREP=?
Test command reports the supported range of values for the +CGEREP
command parameters.
Reference 3GPP TS 27.007
3.5.3.7.4. GPRS Network Registration Status - +CGREG
+CGREG - GPRS Network Registration Status
AT+CGREG=[<n>]
Set command controls the presentation of an unsolicited result code
+CGREG: (see format below).
Parameter:
<n> - result code presentation mode
0 - disable network registration unsolicited result code
1 - enable network registration unsolicited result code; if there is a change in the
terminal GPRS network registration status, it is issued the unsolicited result
code:
+CGREG: <stat>
where:
<stat> - registration status
0 - not registered, terminal is not currently searching a new operator to register
to
1 - registered, home network
2 - not registered, but terminal is currently searching a new operator to register
to
3 - registration denied
4 - unknown
5 - registered, roaming
2 - enable network registration and location information unsolicited result code; if
there is a change of the network cell, it is issued the unsolicited result code:
+CGREG: <stat>[,<lac>,<ci>]
where:
<stat> - registration status (see above for values)
<lac> - location area code in hexadecimal format (e.g. "00C3" equals 195 in
decimal)
<ci> - cell ID in hexadecimal format.
AT+CGREG?
Read command returns the status of result code presentation mode <n> and the
integer <stat> which shows whether the network has currently indicated the
registration of the terminal in the format:
To Next Page
Loading...
Need help?
General
