HE863 family AT commands reference guide
80377ST10083a Rev.6 – 2012-11-12
Reproduction forbidden without written authorization from Telit Communications S.p.A.- All Rights Reserved. Page 96 of 229
+CGEQMIN – 3G Quality Of Service Profile (Minimum Acceptable)
1 – yes
2 – no detect
3 – subscribed value
<Transfer delay > Transfer delay (milliseconds)
0 - subscribed value
10~150 - in 10 ms steps
200~950 - in 50 ms steps
1000~4000 - in 50ms steps
<Traffic handling priority > Traffic handling priority
0- subscribed value
1…3
Note: a special form of the Set command, +CGEQMIN=<cid> causes the requested
profile for context number <cid> to become undefined.
Note: +CGEQMIN= command returns ERROR.
AT+CGEQMIN?
Read command returns the current settings for each defined context in the format:
[+CGEQMIN: <cid>,<Traffic class>,<Maximum bitrate UL>,<Maximum bitrate
DL>,<Guaranteed bitrate UL>,<Guaranteed bitrate DL>,<Delivery
order>,<Maximum SDU size>,<SDU error ratio>,<Residual bit error
ratio>,<Delivery of erroneous SDUs>,<Transfer delay>,<Traffic
handling><CR><LF>]
[+CGEQMIN:…]
If no PDP context has been defined, it has no effect and ERROR result code is
returned.
AT+CGEQMIN=?
Test command returns as a compound value the type of the current PDP context and the
supported values for the subparameters in the format:
+CGQMIN: <PDP_Type>,(list of supported <Traffic class>s),
(list of supported <Maximum bitrate UL>s),(list of supported <Maximum bitrate
DL>s),(list of supported <Guaranteed bitrate UL>s),(list of supported
<Guaranteed bitrate DL>s),(list of supported <Delivery order>s),(list of
supported<Maximum SDU size>s),(list of supported<SDU error ratio>s),(list of
supported<Residual bit error ratio>s),(list of supported <Delivery of erroneous
SDUs>s),(list of supported <Transfer delay>s),(list of supported <Traffic handling
priority>s
Example AT+CGEQMIN=1,0,384,384,128,128,0,0,”0E0”,”0E0”,0,0,0
OK
AT+CGEQMIN?
+CGEQMIN: 1,0,384,384,128,128,0,0,”0E0”,”0E0”,0,0,0
OK
To Next Page
Loading...
Need help?
General
