Telkonet Aida - JBox Vertical Mud Ring Installation

thermostat). If installing on a heat pump, ensure that Y1 and W1 are jumped
together.
12. Connect wires and harnesses as per the tables.
13. Verify each wire is secure by gently tugging on it.
14. Hold backplate against wall at appropriate height. Using a pen, level-mark your
holes.
15. Use appropriate drill for anchor and insert anchors into holes.
16. Screw backplate to the wall and into the anchors. Re-check that it is still level.
17. Screw the wires to the screw terminal block.
18. Next: See Steps Common to all Low Voltage Installation Methods on page 16.
JBOX USING VERTICAL MUD RING INSTRUCTIONS
NOTE: Requires Telkonet JBox Adapter Plate and two #6-32 1” screws.
19. Strip the LINE wire back 0.25 inches.
20. Cap the LINE wire with a wire nut or electrical tape.
21. Cut the COMMON wire so the copper is flush with the insulation.
22. Strip all wires except for COMMON back 0.25 inches.
23. Determine which end of the adapter should be situated on top, and which end
should be situated on the bottom.
24. Mount the Aida mounting plate to the mud ring with two #6-32 1” screws.
25. Mount Aida backplate on top of JBox adapter plate, using four #5 ½” coarse
thread screws.
26. Screw down each wire to the matching screw terminal on each block. (If con-
trolling proportional valve or ECM fan, any unused wires must be capped accord-
ing to NEC standards.)
NOTE: For variable output connections: See Analog Outputs on page 21.
27. Connect all other wires and harnesses.
28. Mount the Aida backplate on top of JBox adapter plate, using four #5 ½” coarse
thread screws.
29. Feed wire harnesses through the applicable holes in the backplate. High and
low voltage wires must be fed through separate holes.
30. Connect the harnesses to the Aida.
31. Ensure backplate has appropriate jumpers between R, SW1 and SW2. If
installing on a head pump, ensure there is a jumper between Y1 and W1.
Chapter 2: Installation 15
Aida IOM