OC441665
Release 1. 22jan16jh
This document is TELMA’s property. It cannot be either forwarded to an outsider, printed, reproduced or disclosed without TELMA’s authorization. Page
16 / 23
If you replace the hub on retarder LVRS600, please go directly to the picture 4-L.
Specific operations in case of hub replacement on AF5 retarder.
4-I 4-J
4-K
Check that the Vistop® lock washer steel is
at 8 to 10 mm of the head screw.
On axle side, toggle the pole shoes plate to
the poles.
Take care not to wedge the spring washers
with the poles during toggling.
8 to 10 mm
Take care to slide the screw correctly in the
pole shoes plate slot.
To Next Page
Loading...
