Telrad Executive set with expanded display - Messages; Sending messages; Selecting predefined messages

Executive set with expanded display 21
MESSAGES
If after dialing an extension, there is no answer or you hear
busy tone, you can send a basic message or a message
from a predefined list, which appears on the display of the
extension you called.
When you send a basic message, display telephones show
"CALL" followed by your extension name or number (e.g.
"CALL STEVE").
When you send a predefined message, display telephones
show the text of the message, followed by your extension
name or number e.g. ("GONE OUT STEVE").
SENDING MESSAGES
To send a basic message
After dialing an extension:
1. Press {MESSAGE}.
2. Press [SPKR] or replace the handset.
The message is sent.
To select and send a predefined message
You can select a message from a predefined list (see a list
of system messages at the end of this guide).
After dialing an internal number:
1. Press {MESSAGE}.
The first five of the available messages are displayed.