Teltonika FMB122 First Start-Up Quick Start Guide

https://wiki.teltonika-gps.com/view/FMB122_First_Start
FMB122 First Start
Main Page > Advanced Trackers > FMB122 > FMB122 First Start
GNSS/GSM/Bluetooth tracker with external GNSS, internal GSM antennas and internal
battery
Contents
1 How to insert SIM card and connect the battery
2 Battery placement after complete device disassembling
3 2x6 socket pinout
3.1 PC Connection (Windows)
3.2 How to install USB drivers (Windows)
3.3 Configuration (Windows)
3.4 Quick SMS configuration
4 Mounting recommendations
5 Installation photos
6 Safety information
6.1 Precautions
How to insert SIM card and connect the battery
Gently remove FMB122 cover using plastic pry tool from both sides.1.
Note: To properly open a new case please watch this video.
Insert SIM card as shown with PIN request disabled or read Security info how to enter it2.
later in Teltonika Configurator. Make sure that SIM card cut-off corner is pointing forward to
slot. SIM slot 1 is closer to PCB, SIM slot 2 is the upper one.
Connect battery as shown to device. Position the battery in place where it does not obstruct3.
other components.
After configuration, see “PC Connection (Windows)”, attach device cover back.4.
Device is ready to be installed.
SIM card insertion/removal must be performed when device is powered off – external voltage
and internal battery disconnected. Otherwise SIM card might be damaged or device will not
detect it.

Teltonika FMB122 Specifications

General

GNSS	GPS, GLONASS, GALILEO, BEIDOU
Position Accuracy	2.5 m
Hot start	1 s
2G bands	850/900/1800/1900 MHz
SMS	Yes
Bluetooth peripherals supported	Yes
Digital Inputs	2
Digital Outputs	1
Analog Inputs	1
1-Wire	Yes
CAN adapter support	Yes
LED indication	Yes
Sleep modes	Yes
SMS configuration	Yes
GPRS commands	Yes
Fuel monitoring	Yes
Ignition detection	Yes
GNSS Channels	72
Power Supply Range	10 - 30 V
Warm start	25 s
Cold start	< 35 s
GSM	Quad-band
Data transfer	GPRS
Bluetooth	Yes, v4.0
SIM	Mini SIM
Memory	16 MB
Operating temperature	-40 °C to +85 °C
Storage temperature	-40 °C to +85 °C
Operating humidity	Up to 95% non-condensing
Configuration and firmware update	FOTA
Time Synchronization	Yes
Time To First Fix (Cold Start)	< 35 s