https://wiki.teltonika-gps.com/view/FMC225_First_Start
FMC225 First Start
Main Page > Advanced Trackers > FMC225 > FMC225 First Start
Advanced LTE terminal with GNSS and LTE/3G/GSM connectivity, RS485/RS232 interfaces
and backup battery.
Contents
1 How to insert SIM card and connect battery
2 Battery placement after complete device disassembling
3 2x6 socket pinout
3.1 PC Connection (Windows)
3.2 How to install USB drivers (Windows)
3.3 Configuration (Windows)
3.4 Quick SMS configuration
4 Mounting recommendations
5 Installation photos
6 Safety information
6.1 Precautions
How to insert SIM card and connect battery
1.You will receive your device partly closed.
2.Gently remove top and bottom covers.
3.Insert SIM card as shown with PIN request disabled or read our Wiki how to enter it later in
Teltonika Configurator. Make sure that SIM card cut-off corner is pointing outward from slot. SIM
slot 1 is closer to PCB, SIM slot 2 is the top one.
4.Connect battery as shown to device. Position the battery in place where it does not obstruct other
components.
5.After configuration, see “PC Connection (Windows)”, attach device top and bottom cover back and
press them twice to the full closure.
6.Make sure that product casing is closed correctly.
This device has an IP67 casing with a two-phase closing, that ensures a reliable protection and ease of use. Please make sure
that product casing corner clips are fixed tightly and cable is connected to the device in order to maintain the degree of IP67
protection.
To Next Page
Need help?
General
