https://wiki.teltonika-gps.com/view/FMM130_First_Start
FMM130 First Start
Main Page > Advanced Trackers > FMM130 > FMM130 First Start
Advanced CAT M1/GSM/GNSS/BLE terminal with internal antennas and backup battery
Contents
1 How to insert SIM card and connect the battery
2 Battery placement after complete device disassembling
3 2x6 socket pinout
3.1 PC Connection (Windows)
3.2 How to install USB drivers (Windows)
3.3 Configuration (Windows)
3.4 Quick SMS configuration
4 Mounting recommendations
4.1 Installation photos
5 Safety information
5.1 Precautions
How to insert SIM card and connect the battery
Gently remove FMM130 cover using plastic pry tool from both sides.1.
Note: To properly open a new case please watch this video.
Insert SIM card as shown with PIN request disabled or read Security info how to enter it2.
later in Teltonika Configurator. Make sure that SIM card cut-off corner is pointing forward to
slot. SIM slot 1 is closer to PCB, SIM slot 2 is the upper one.
Connect battery as shown to device. Position the battery in place where it does not obstruct3.
other components.
After configuration, see “PC Connection (Windows)”, attach device cover back.4.
SIM card insertion/removal must be performed when device is powered off – external
voltage and internal battery disconnected. Otherwise SIM card might be damaged or
device will not detect it.
To Next Page
Need help?
General
