Temposonics
®
E-Series IO-Link
Operation Manual
I 4 I
2.3 Installation, commissioning and operation
The position sensors must be used only in technically safe condition.
To maintain this condition and to ensure safe operation, installation,
connection and service, work may be performed only by qualified
technical personnel.
If danger of injury to persons or of damage to operating equipment
is caused by sensor failure or malfunction, additional safety measures
such as plausibility checks, limit switches, EMERGENCY STOP
systems, protective devices etc. are required. In the event of trouble,
shut down the sensor and protect it against accidental operation.
Safety instructions for commissioning
To maintain the sensor's operability, it is mandatory to follow
the instructions given below.
1. Protect the sensor against mechanical damage during
installation and operation.
2. Do not open or dismantle the sensor.
3. Connect the sensor very carefully and pay attention to the
polarity of connections and power supply.
4. Use only approved power supplies.
5. It is indispensable to ensure that the specified permissible
limit values of the sensor for operating voltage,
environmental conditions, etc. are met.
6. Check the function of the sensor regularly and provide
documentation of the checks.
7. Before applying power, ensure that nobody’s safety
is jeopardized by starting machines.
2.4 Safety instructions for use in explosion-hazardous areas
The sensor is not suitable for operation in explosion-hazardous areas.
2/ See also applicable 5FNQPTPOJDT terms of sales and delivery on
www.UFNQPTPOJDT.com
2.5 Warranty
5FNQPTPOJDT grants a warranty period for the Temposonics
®
position
sensors and supplied accessories relating to material defects and
faults that occur despite correct use in accordance with the intended
application
2
. The 5FNQPTPOJDT obligation is limited to repair or
replacement of any defective part of the unit. No warranty can be
provided for defects that are due to improper use or above average
stress of the product, as well as for wear parts. Under no
circumstances will 5FNQPTPOJDT accept liability in the event of offense
against the warranty rules, no matter if these have been assured or
expected, even in case of fault or negligence of the company.
5FNQPTPOJDT explicitly excludes any further warranties. Neither
the company’s representatives, agents, dealers nor employees are
authorized to increase or change the scope of warranty.
2.6 Return
For diagnostic purposes, the sensor can be returned to 5FNQPTPOJDT
or a repair facility explicitly authorized by 5FNQPTPOJDT. Any shipment
cost is the responsibility of the sender
2
.
For a corresponding form, see chapter "10. Appendix" on page 39.
To Next Page
Loading...