Acoustics:
In normal base operation the wheels, which allow the bed to maintain
its distance from the wall, will make contact with the steel platform
supports of the base creating a contact noise. When entering, exiting
or shifting weight on the base, this contact noise may be audible as the
wheels make contact. This is normal.
2
a temporary power source to get the base to a desired position.
Instructions on how to operate the Battery Backup Strap are on the
Emergency Battery Backup page(s).
Power Ratings:
INPUT: AC 100–240V 50/60 HZ 1.5A
OUTPUT: DC 29V 1.8A
WATTS: 52.2W
®
are: Twin / Twin Long /
Product Ratings:
The lift motors are not designed to operate continuously for more
than two [2] minutes in an eighteen [18] minute time period or
approximately 10% duty cycle. Attempting to circumvent or exceed this
rating will shorten the life expectancy of the product and may void the
warranty.
Weight Limits:
The recommended weight limits on the EASE
Full / Queen / King / Cal King / Cal King Split : 650 pounds
Maximum weight the bed can support per person is 250 pounds with
the weight evenly distributed across the head and foot sections. This
product is not designed to support or lift this amount of weight in
the head or foot sections alone. NOTE: Exceeding the recommended
weight restrictions could damage your EASE
®
and void your warranty.
For best performance, you should enter and exit the EASE
®
while it is
in the flat or fully lowered position.
EASE
®
fits easily inside bed frames, furniture beds and platform beds
that are certified to hold a minimum of 850 pounds. If using this
adjustable base without the legs and placing directly on a bed frame
or platform bed, cross-bed supports (slats) are strongly recommended
to ensure EASE
®
maintains stability during operation.
Fabric Care:
To prolong the life of your fabric, protect from direct sunlight whenever
possible. For spot cleaning, wipe area with a light damp sponge or
vacuum with a soft brush attachment to remove particles. Keep at a
minimum of 30cm (12 inches) away from direct heat sources.
For deeper cleaning, blot liquid spills with a clean dry cloth. Wipe with
a clean cloth dampened with warm water. Do not wet excessively.
A soft bristle brush may be used to remove ingrained soil. Avoid
scratching by gentle brushing. Wipe with a clean cloth dampened with
warm water to remove residues after brushing. Dry in shade away from
direct heat.
If persistent marks remain visible after cleaning, seek professional
advice.
SAVE THESE INSTRUCTIONS.
FCC Compliance:
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
CAN ICES-3 (B)/NMB-3(B)
safety precautions and usage statements
Exceeding this weight restriction could damage the bed
and/or cause injury and will void the warranty.
To Next Page
Loading...
