6
installation guide
STEP 1
STEP 4
STEP 2
Always use two people when setting up the base.
Place the bed base box in a desired location with the bottom of
the box facing up.
Remove the binding straps and packing materials, making sure
not to puncture the box with any sharp objects.
Remove the bed base from the box. Unfold the bed making sure
to keep the bottom of the bed facing upwards.
STEP 3
To sync two bases see detailed installation
instructions on pages 10-11.
To install Headboard Brackets (sold separately)
see instructions on page 12.
It is recommended to leave the battery
backup strap attached to the power supply
for use when needed. 2 9V batteries (not
included) will be required for its use.
For customer support, call Customer Service AUS: 1800 763 498, NZ: 0800 483 6789
Legs are shipped fully assembled. Alternative heights in 3"
increments can be achieved by removing leg segments.
To install the legs, thread the leg into frame, and tighten by hand.
Do
not over tighten.
To Next Page
Loading...
