Tenda 3G150M - Chapter 5 Advanced Settings; LAN Setting

31
Chapter 5 Advanced Settings
5.1 LAN Setting
This section will describe how to configure the TCP/IP
parameters.
5.1.1 In 3G Router mode, WISP mode, Wireless Router mode,
please configures the LAN port parameters as the below
diagram (Note: In Wireless mode, you can only configure the
device until you using the wireless access way.).
¾ MAC Address: The device’s physical MAC address as
seen on your local network is unchangeable.
¾ IP Address: The Router’s LAN IP addresses
(not your PC’s IP address). 192.168.0.1 is the default value.
¾ Subnet Mask: It’s shown the Router’s subnet mask for
measurement of the network size. 255.255.255.0 is the
default value.
Notice:Once you modify the IP address, you need to remember