61
Chapter 9 Traffic Control
Traffic control is used to limit communication speed in the LAN
and WAN. Up to 20 entries can be supported with the capability
for at most 254 PCs' speed control, including for IP address range
configuration.
¾ Enable Traffic Control: To enable or disable the internal IP
bandwidth control. The default is disabled.
¾ Interface: To limit the uploading and downloading
bandwidth in WAN port.
¾ Service: To select the controlled service type, such as HTTP
service.
¾ IP Address：The range of IP addresses, it can be a single IP
To Next Page
Loading...
