46
Step 2 Port Isolation: Set Port Isolation to Enable.
Step 3 VLAN ID: Set VLAN ID, such as 3-10, or 12. One port can only be set with one VLAN ID, but can be
grouped into different VLANs.
The hyphen (-) means “consective”, and the comma (,) means “and”. For example, 3-10, 12 includes 9 VLAN IDs through
VLAN3 to VLAN10, as well as VLAN12.
Step 4 LAN port: Select LAN port corresponding to the VLAN ID.
Step 5 Click Add, the added rule shows in the VLAN list.
----End
To delete a VLAN rule, click corresponding to the rule. You cannot modify a rule but delete it and then add
again.
You need to reboot the device to activate the settings after settings modified.
After adding a VLAN rule, PVID serves as VLAN 1, a port to receive any data.
To Next Page
Loading...