46
Parameter description
It specifies whether or not to enable the alarm function.
It specifies alarm type of the camera.
Motion Detection: When image change is detected, the camera will send
alarm information and monitoring image to TDSEE.
S-motion Detection: When S-motion change is detected, the camera will
send alarm information and monitoring image to TDSEE.
It specifies the time interval at which the camera sends alarm messages. You
can select it according to the actual condition.
It specifies the detection sensitivity of the camera.
By default, the detection sensitivity is Medium, you can select High or Low
according to the actual condition.
It specifies the period in which the camera generates alarms.
You can select the period preset by the system, or customize it as required.
After the function is enabled, the camera flashes white, and produces audio
alert when the alarm is detected.
It specifies alarm prompt tone of the camera.
You can select the prompt tone preset by the system, or record it by yourself
when the sound and light alarm function is enabled.
When the sound and light alarm function is enabled, if the camera detects an
alarm image, the camera will flash white light.
To Next Page
Loading...