TEG1216T/1224T Giga Web Smart Switch
（Notice：You can point the “work mode“ only when you choose
the “disabled” in this item）
¾ work mode：Can set the 10Mbps full/half duplex mode ，
100Mbps full /half duplex mode ; 1Gbps full duplex mode.
¾ Flow control： support IEEE802.3x flow control for full duplex and
backpressure flow control for half duplex (The switch can change
its flow control mode corroding to its port duplex mode
automatically ）
¾ Default 802.1P Priority ： optional 0－7 PRI.
¾ VLAN Default ID(1~4094)：Default VLAN ID（ used for 802.1Q
VLAN） is “1”，the ID must be the integer between 1~4094，
appointed VLAN must already existed.
¾ Auto-learning： MAC address Auto-learning. If disable the MAC
address Auto-learning, the previous learned MAC address
may aged in some time, and it can not learn the new MAC
address any more, so it can not communicate through this port.
Disable Auto-learning can help the Port Static MAC address
binding, and reach the best security effect; The other unknown
MAC address device can not access into the network except the
appointed (binding) MAC address.
Port status table: Display all the port current setting status, as
below:
16
To Next Page
Loading...
