TEG1216T/1224T Giga Web Smart Switch
The others are named work mode, must keep the same work mode
as its object, or the object work as a auto-negotiation mode,
otherwise the communication can not go through. Flow control is
used to connect the both data flow.
It’s a way to prevent the receptor buffer overflow to package.
The port management setting will affect the port bandwidth control,
port mirror, Trunk function.
3.3.1 Port Setting
Port Configuration: Switch basic function setting, includes: ports Enable
or disabled, work mode, flow control and MAC address learning function
control, the detailed specification is as below:
¾ Port ： 24 optional 10/100/1000Mbps Port，choose the relative
port if need to set .
¾ Enable/Disabled ： Enable or Disabled the traffic of the
corresponding port， the port will no communication but still
connected when you choose the “Disabled” （Notice：If without
special demands, please DO NOT disabled the port）
15
¾ Auto-negotiation：Enable or Disabled Auto-negotiation function
To Next Page
Loading...
