300Mbps Wireless Access Point
Click “enable” or “disable” to enable and disable SNMP management.
Setting Explanation
² Contact Set the name to access the AP. Usually set the
administrator’s name.
² Device Name Set the AP’s name, such as Tenda_300A.
² Location Set the AP’s network location.
² Read Community: Indicates the community read access string to
permit reading this AP’s SNMP information. The default is Public.
² Read/Write Community: Indicates the community read/write
access string to permit reading and re-writing this AP’s SNMP
information. The default is Private.
To Next Page
Loading...
