3
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future
reference.
• When using electrical appliances basic safety precautions should always be
followed.
• Do not use the meter in environments exposed to explosive gas, vapour or dust, in
direct sunlight or high radiation.
• There are no user serviceable parts in this product. Refer all servicing to qualied
personnel.
• The voltage detector is designed to be used by skilled persons and in accordance
with safe methods of work.
• The different indicating signals of the voltage detector (including the ELV limit
indication) are not to be used for measuring purposes.
• Never use the equipment while the voltage is beyond the range (referring to
technical specication parameters) and above 800V.
• To ensure normal operation of the tester, measure a known voltage value rst.
• When using the tester always keep your ngers behind the nger safety guards.
• Do not use the tester if there is a functional failure or no functional indication.
• Never test in wet conditions.
• Display functions will only work when the temperature is between -15°C and
+45°C and relative humidity is <85%.
• Ensure the batteries (not included) are inserted correctly, observing the plus and
minus marks on both the batteries and the compartment.
• Fit a full set of batteries at one time.
• Remove dead batteries from the meter, or if it is not going to be used for a long
time.
• Never mix old and new batteries together, or different types of batteries.
• Never dispose of batteries in a re, or attempt to recharge ordinary batteries.
FEATURES
• LED indication (72-3570 & 72-3575).
• LCD voltage and frequency display (72-3575 & 72-3580).
• AC/DC measured up to 690V.
• Detects a live wire by single test pen measurement.
• Continuity measurement.
• Indicates the phase relationships among three-phase AC.
• Silent mode.
• Detection without batteries (72-3570 & 72-2375).
• Torch and backlight.
• Self-inspection function.
• Low battery indication and measured voltage over-range indication.
• RCD test.
• Automatic standby.
To Next Page
Loading...
