To Next PageTo Next PageWhy does the battery of my Tennant S7 not hold its charge?
If the battery of your Tennant Blower isn't holding its charge, it could be due to a lack of liquid (if it's a lead-acid battery), so top it up. It could also be a loose terminal, so tighten it.
Why side brushes of my Tennant S7 do not rotate?
If the side brushes on your Tennant Blower do not rotate, it's likely that the belt is broken. Replace it to solve the problem.
What to do if Tennant S7 releases dust when working?
If your Tennant Blower releases dust while in use, it could be due to worn flaps or a clogged filter. Try replacing the worn flaps or cleaning the filter to resolve the issue.
Why won't my Tennant Blower machine start?
If your Tennant Blower machine isn't starting, the battery terminals might be detached, so check them. Alternatively, the batteries might be discharged; in that case, recharge them.
What to do if dust comes out of the Tennant Blower fan?
If dust is coming out of the fan of your Tennant Blower, the filter may be broken, positioned incorrectly or the gaskets may be worn. Replace the broken filter, reposition the incorrectly positioned filter, or replace worn gaskets.
Why the suction motor isn't working in my Tennant Blower?
If the suction motor in your Tennant Blower isn't working, it could be due to the motor being burned out or a detached wire. In both cases you should contact service centre.
What to do if the centre brush won't turn on my Tennant S7 Blower?
If the centre brush on your Tennant Blower won't turn, it may be due to a broken belt, which you should replace. It could also be that the gear motor is damaged or the wire is detached, in that case you should contact service centre.
How to fix Tennant Blower brushes that wear out too quickly?
If the brushes on your Tennant Blower are wearing out too quickly, it's possible that the brushes are pressed too hard. Try to adjust them.
What to do if my Tennant Blower doesn’t start?
If your Tennant Blower doesn't start, first check the battery terminals to ensure they are properly attached. If the terminals are fine, the batteries may be discharged and need to be recharged.
Why is my Tennant Blower releasing dust when working?
If your Tennant Blower releases dust while you're working, it could be due to worn flaps, which should be replaced. Alternatively, the filter might be clogged and needs cleaning.
Instructions for attaching the side brush to the machine.
Steps to attach and secure the machine's handle.
Procedure for recharging the machine's battery.
Information on configuring the battery charger settings.
Troubleshooting common battery charger issues.
Daily cleaning procedure for the pre-filter.
Procedure for cleaning the main suction filter.
Guidance on when and how to replace the suction filter.
Instructions for replacing the outer side flaps.
Instructions for replacing the inner side flaps.
Procedure for replacing the centre flap.
Steps to replace the belt for the side brush.
Steps to replace the machine's drive belt.
Procedure for replacing the drive cable.
Procedure for replacing the side brush lifting cable.
General
