TX-1 Series Instrument www.tensitron.com pg. 7
o Set-Point feature: allows user to specify high and low tension points which
are then shown on the main display as an active, color-changing bar graph.
o Rechargeable NiMH batteries with power supply provided. Approximately 12
hours of continuous use depending on backlighting intensity.
o Power supply operates with input voltages from 100 – 240V and includes
several interchangeable adapters allowing use with European, Australian,
US, British, and other plug configurations.
o Optional features, including: Custom Rollers, Speed and Length monitoring,
Analog Output or Serial Output.
o Optional magnetic or rigid Mounting Bracket.
o All models typically available from stock.
o Numerous application-specific models available.
o Durable, lightweight carrying case with protective foam inserts. (See Figure
2.)
o All instruments are factory-calibrated and ready to use. Calibration
certificate is included. All calibration values are traceable to National
Standards.
5. BASIC OPERATION
• Charging Instrument Batteries
1. Connect power supply cable to the instrument.
2. Plug the power supply into a power source with input voltages between 100 –
240 VAC.
3. A full charge of the battery assembly requires several hours of charging.
4. The battery pack assembly cannot be overcharged.
5. The instrument will remain on while connected to its power supply.
6. The battery charge level is indicated in the upper, right-hand corner of the
display.
To Next Page
Loading...
