1-3
Caution
Do not put a cloth on the motor.
Failure to observe this may cause overheating or ignition.
Do not touch the motor body during operation or
immediately after the stop of operation.
Failure to observe this may cause a burn due to high
temperature of the pump.
If any unrestorable failure occurs on the pump or if
you find anything wrong with the pump, stop the
operation immediately and turn off the power, and
then contact Teral Inc. or the service company.
Otherwise, it may lead to an accident.
Do not operate the pump when tools or other
items are placed on the pump.
Otherwise, it may lead to injury and/or damage.
Check to verify that the product is exactly what
you ordered.
The use of a wrong product may cause an injury or failure.
Ensure to carry out inspection according to the
maintenance checklist.
Otherwise, you cannot prevent potential failures, thus
leading to a higher risk of accidents.
Do not place any obstacle that disturbs ventilation,
around the product.
Failure to observe this may cause a fire.
Do not provide any strainer at the tip of the pump.
Failure to observe this may cause the strainer to come off,
resulting in an injury or breakage.
Do not operate the pump with a frequency beyond
60 Hz.
Failure to observe this may cause a burnout or fire.
Do not place any combustible objects around the
product.
Failure to observe this may cause a fire.
Be sure to install an overcurrent protection device.
Installation of the device is obliged by the Technical
Standards for Electrical Equipment. Failure to observe this
may cause a fire or breakage due to damage to the product.
In addition, it is recommended to install a protective device,
e.g. an earth leakage circuit breaker.
Do not touch the pump impeller, fastening bolts,
strainer and other items with bare hands.
Failure to observe this may cause an injury or breakage.
Do not run the pump with its strainer removed.
Failure to observe this may cause an injury or breakage.
Do not use any operating fluid beyond the
viscosity limit.
Failure to observe this may cause a burnout or fire.
Do not touch the impeller and other parts after
removing the strainer.
Failure to observe this may cause an injury.
Do not touch any terminal or wire when measuring
the insulation resistance.
Failure to observe this may cause an electric shock.
Do not use thinner or benzine for cleaning the
product.
Failure to observe this may cause the product to be
discolored or the coating to be peeled off.
After power-off, do not restart the pump until it
comes to a complete stop.
Failure to observe this may cause an excessive load to act
on the pump spindle, resulting in a shortened service life of
the pump.
When lifting the product, pay attention to its center
of gravity.
Failure to observe this may cause the product to topple over
or fall down, leading to an injury.
If using a solvent for cleaning the product, pay
attention to the handling and use environment of
the solvent.
Failure to observe this may cause poisoning.
When lifting the product, give attention to its
weight. Do not allow any product heavier than 15
kg to be lifted by a single person.
Failure to observe this may put a burden on the body,
leading to an injury.
When disposing of the product, treat it as industrial
waste.
If adopting star-delta starting, use a starter with an
electromagnetic switch (three-contactor type) on
the primary side.
Failure to observe this may cause a fire.
To Next Page
Loading...
