Terasic DE0-CV User Manual

DE0-CV User Manual
1
www.terasic.com
May 4, 2015

Terasic DE0-CV Specifications

General

Brand	Terasic
Model	DE0-CV
Category	Motherboard
Language	English

Summary

Chapter 1 Introduction

Chapter 2 Control Panel

2.1 Control Panel Setup

Guides users on installing and launching the DE0-CV Control Panel software.

Chapter 3 Using the Starter Kit

3.1 Configuration of Cyclone V FPGA on DE0-CV

Covers methods for configuring the Cyclone V FPGA on the DE0-CV board.

Configuring the FPGA in JTAG Mode

Details the steps for configuring the FPGA using JTAG.

Configuring the EPCS64 in AS Mode

Explains the process of configuring the EPCS64 serial configuration device.

3.2 Using the LEDs and Switches

Explains how to use user-defined LEDs, slide switches, and push-buttons on the board.

3.5 Using 2x20 GPIO Expansion Headers

Details the usage and pin assignments of the GPIO expansion headers.

3.6 Using VGA

Explains how to use the VGA output interface and its timing specifications.

3.8 Micro SD-Card Socket

Details the functionality and pin assignments of the Micro SD card socket.

3.9 Using SDRAM

Explains the usage and pin assignments of the 64MB SDRAM.

Chapter 4 DE0-CV System Builder

4.3 Using DE0-CV System Builder

Provides detailed instructions on using the DE0-CV System Builder.

Chapter 5 Examples of Advanced Demonstrations

5.2 SDRAM Test in Nios II

Illustrates SDRAM testing using Nios II.

5.3 SDRAM Test in Verilog

5.5 Micro SD Card file system read