Terasic DE10-Lite User Manual

DE10-Lite
User Manual
1
www.terasic.com
May 11, 2018

Terasic DE10-Lite Specifications

General

Clock Input	50 MHz
Onboard Clock	50 MHz
User I/O Pins	40
USB Blaster	Yes
Switches	10
Buttons	2
Power Supply	5V

Summary

Chapter 1 Introduction

1.3 Layout and Components

Describes the features and design of the DE10-Lite board's key components.

1.4 Block Diagram of the Board

Chapter 2 Control Panel

2.1 Control Panel Setup

Procedures for installing and activating the DE10-Lite Control Panel software.

2.2 Controlling LEDs and 7-segment Displays

2.4 SDRAM Controller and Programmer

Writing and reading data to/from the DE10-Lite board's SDRAM.

2.5 Accelerometer Usage

Utilizing the onboard G-Sensor to measure acceleration and movement.

2.6 VGA Display Output

Generating and outputting color patterns to a VGA monitor.

Chapter 3 Using the Starter Kit

3.1 MAX 10 FPGA Configuration

Methods for configuring the MAX 10 FPGA on the DE10-Lite board.

3.3 User Input/Output Devices

3.4 7-segment Displays Usage

3.5 2x20 GPIO Expansion Headers

3.6 Arduino Uno R3 Expansion Header

3.7 Analog-to-Digital Converter (ADC)

3.8 VGA Output Interface

3.9 SDRAM Memory Interface

3.10 Accelerometer Sensor Integration

Chapter 4 DE10-Lite System Builder

4.2 General Design Flow

4.3 System Builder Usage Procedures

Detailed instructions on how to use the DE10-Lite System Builder GUI.

Chapter 6 Programming the Configuration Flash Memory

6.1 Internal Configuration Modes

Explains different modes for configuring the MAX 10 device via internal flash.

6.2 Dual Compressed Images Feature

How to use the dual image boot function for the MAX 10 device.