DE10-Nano
D8M RTL
1
www.terasic.com
February 24, 2017
1
1
.
.
I
I
n
n
t
t
r
r
o
o
d
d
u
u
c
c
t
t
i
i
o
o
n
n
This document illustrates how to setup the Camera demo on the DE10-Nano and the
D8M-GPIO as shown in shown in Figure 1. The basic design content is also included.
In this demonstration, please refer to the DE10-Nano user manual. For details about
the D8M-GPIO, please refer to the user manual of D8M-GPIO daughter card.
Figure 1 Camera Demo
2
2
.
.
S
S
y
y
s
s
t
t
e
e
m
m
R
R
e
e
q
q
u
u
i
i
r
r
e
e
m
m
e
e
n
n
t
t
s
s
The following items are required to perform this demonstration:
DE10-Nano and power supply
D8M-GPIO
HDMI-Monitor
3
3
.
.
E
E
x
x
e
e
c
c
u
u
t
t
e
e
D
D
e
e
m
m
o
o
n
n
s
s
t
t
r
r
a
a
t
t
i
i
o
o
n
n
Please follow the procedures below to setup the demonstration
1. Make sure both Quartus II and USB-Blaster II driver are installed on the host
PC.
2. Make sure Quartus Prime 16.0 Standard or later is installed on your host PC.
3. Power off the DE10-Nano board
4. Make sure the MSEL[4:0] is set to 10010.
5. Mount the D8M-GPIO onto the 2x20 GPIO_0 expansion header of the DE10-
Nano.
6. Power on the DE10-Nano Board.
7. Execute the demo batch file “test.bat” from the directory
\FPGA\DE10_NANO_D8M_RTL\demo_batch
8. Now, you should see the HDMI monitor
To Next Page
Need help?
General
