What to do if my Terrano Cell Phone stops responding?
If your Terrano Cell Phone stops responding, you can reset it by turning it off and then on again. Press the power button for 2 seconds to perform the reset.
How to reset pairing on Terrano Cell Phone?
To reset the pairing on your Terrano Cell Phone (deleting all paired devices), put the device in Standby mode, then press and hold the button for 6 seconds until the LED flashes RED and BLUE. After that, press the button for 2 seconds until the LED flashes 5 times in PURPLE.
What to do if my Terrano Headsets unit stops responding?
If your Terrano Headsets unit stops responding, reset it by turning it off and then on again. Press the power button for 2 seconds to do this.
How to reset pairing on Terrano terrano-x?
To reset pairing on your Terrano Headsets (deleting all paired devices), put the headset in Standby mode, then press and hold the power button for 6 seconds until the LED flashes RED and BLUE. Next, press the power button for 2 seconds until the LED flashes 5 times in PURPLE.
Step-by-step guide for pairing intercom units.
How to initiate a Click-to-Link call.
How to terminate or cancel a Click-to-Link call.
Steps to connect phones and music players via Bluetooth.
Managing calls and operations with a connected mobile phone.
Controlling music playback from connected devices.
Procedure to restart the unit if it becomes unresponsive.
Procedure to clear all previously paired devices.
General warnings about product usage while riding.
Information on potential health risks like hearing loss and pacemaker interference.
To Next Page
General