Note:
Laser offset: The laser beam is offset 16mm(0.63in) from
the focal lens. Choose a sampling spot that
is large enough to include the laser offset.
Surface Temperatures: The thermometer will measure
the first surface it detects, even a
glass cover, dust, or fog. Make
sure the object is not obstructed.
3. Type - K measuring :
a). Under the Infrared measuring mode, press MODE
button entering into Type - K measuring.
b). Under Type - K measuring mode, press MEAS button
for 3 secs to power off the meter.
4. Selecting
℃
/
℉
unit
While powering on the meter, the temperature unit that
appears in LCD would be the last unit you measured. If user
wants to change the temperature unit, first of all, user has to
power-off the meter, then press & hold (℃) or
(℉) and press MEAS button to power on the meter and get
the proper unit.
Ⅷ. MODE SETTING
Press MEAS button to power on the meter, then press & hold
MODE button for 3 seconds entering into the setting mode for
option. While flashed “SET” symbol appears in LCD, user
should press to choose the setting mode for
Infrared
or Type K measurement.
It is under the parameter settings of infrared measurement if
“ K ” doesn’t appear in LCD.
12
1. Parameter settings for Infrared measuring:
Under the infrared parameter setting mode, LCD will show
, press MODE button to select in turn for setting “
ε
”,
“ALMÇ”, ”ÈALM”, press MODE button again to escape the
setting mode and return to the general measurement.
Note: In the setting mode, if users don’t push any button in
15 seconds, then it will escape from setting mode and
enter into Infrared temperature measuring mode.
2. Parameter settings for Type-K measuring:
Under the Type-K parameter setting mode, LCD will show ,
press MODE button to select in turn for setting
“ALMÇ” , ”ÈALM”, press MODE button again to escape the
setting mode and return to the general measurement.
Note: In the set mode, if users don’t push any button in 15
seconds , then it will escape from setting mode and
enter into Type K temperature measuring mode.
ε
: Emissivity, users can press or button to
adjust parameter.
ALMÇ: Hi Alarm Function. Press or to set up a
value as an alarm value, while the measurement
exceed it, the beeper will beep and “ALMÇ” symbol
will appear in LCD.
ÈALM: Lo Alarm Function. Press or to set up a
value as an alarm value, while the measurement low
it, the beeper will beep and “ÈALM” symbol will
appear in LCD.
MAX: Display the Maximum reading.
13
SET
To Next Page
Loading...
