If the LED flashes red after switching on, the device must be connected to the mains. If the LED
flashes blue after switching on, it is necessary to charge the internal backup battery.
1. Spray both cleaning mops with clean water. Be careful if you spray too much water on the
mops, the device may fall out of the window or may not work properly.
2. Turn the machine upside down and attach two cleaning mops to it, the white part down, the
blue part up. Make sure the mops do not cover any sensor or rubber squeegee.
3. Connect the power cord to the power adapter, connect the device, and then plug the power
adapter into a power outlet.
To Next Page
Loading...
