12
ENG
Consumption Data
Program Capacity
Spin Speed /
Residual Humidity
Drying
Time
Energy
Consumption
Cotton Standard 10kg 1000rpm / 60% 190min 1.76kWh
Cotton Standard 5kg 1000rpm / 60% 112min 0.94kWh
Synthetic Standard 4kg 800rpm / 40% 60min 0.61kWh
• Thick or multi-layered fabrics, e.g. jackets etc., are not easy to dry. You had better choose Cotton Extra
programme.
• As uneven material, thick and multi-layered clothes are not easy to dry, it is better to choose the
appropriate time drying programme to completely dry them if some parts of the clothes are still damp
after programme finishes.
All data are measured in accordance with EN 61121. The actual consumption may differ from the values
given in the table, depending on the amount of the laundry, type of fabric, residual moisture and any
additional functions selected.
NOTE
MAINTENANCE
Cleaning and Care
Empty the water container
1. Pull out and hold the water container with two hands.
2. Tilt the water container, pour out the condensate water into
the basin.
3. Install the water container.
WARNING!
• Empty the water container after each use. Once the water
container is filled completely, the programme will be paused
and the ” ” icon will light. After the container is emptied, the
dryer can be restarted by pressing button.
• Do not drink the condensate water.
Clean the filters
Clean the filter door
This dryer has a primary door lint filter and a base filter in front of the heat exchanger for additional
protection. Make sure you clean the door filter after each cycle. The base filter need to be cleaned after each
fifth drying programme.
1. Open the door.
2. Take out the door filter.
3. Open the filter and remove the fluff on the
filter, you can clean it in running water.
4. Dry the door filter thoroughly before installing
it back.
NOTE
Take notice of the correct orientation
before to insert the door filter.
Door Filter
To Next Page
Loading...