14
ENG
Many malfunctions and faults that might occur in daily operation can be easily remedied. Time and money
will be saved because a service call won’t be needed.
The following guide may help you to find the reason for a malfunction and correct it.
TROUBLESHOOTING
Display Reason Solutions
“E32” Humidity sensor error
Please contact your local service center if the
problem occurs.
“E33” Temperature sensor error
“E64” BLDC motor communication error
“E82” PCB communication error
“ “
Water pump failure or water level
sensor failure
Container is full Empty container
WARNING!
• Only authorised technicians can carry out repairs.
• If the LED displays other prompt and the dryer does not work, please call the
service.
Problem Solution
Display is not on
• Check if the power supply works.
• Check if the mains plug is inserted.
• Check the selected programme .
• Press the button.
“ ” is lighting
• Check the water container. If it’s full, please pour out the condensate
water and restart the dryer.
• If the container is not full, please restart the dryer directly.
• If the “ ” icon is still lighting after you have finished the first two
steps, please call the service.
“ ”is lighting
• Clear lint filter.
Dryer does not start
• Connect the tumble dryer to the mains.
• Turn on the tumble dryer.
• Check the the door is closed.
• Check the programme is set.
• Press the button.
Degree of dryness was not
reached or drying time too long
• Clean lint filter and heat exchanger.
• Empty the water container.
• Check the drain hose.
• Check installation place is appropriate.
• Keep the air inlet clean.
• Use higher drying intensity level programme or time programme.
There are humming noises
• The compressor is operating. These noises are quite normal and do
not indicate a fault.
The dryer switches off at the
end of the programme
• The dryer switches off automatically for energy saving. This is not an
error but a normal function.
NOTE
Before you call the service, please check if you have dealt with the problems yourself
consulting the user instructions.
To Next Page
Loading...