Tessonics F1 - Screen Protector

8
O Mode
All system functions are turned o to conserve power. The system does not respond
to the pen or other input. The system boots at the next system power-on.
Note: The system consumes the same amount of power whether it is in Save-to-Disk
mode or O mode.
Your system can be congured to enter some of these states automatically aer a period of
inactivity to conserve battery power.
4.3 Screen Protector
Using a screen protector will help insure that the screen remains as clear as possible.
When installed, the screen protector becomes a durable, replaceable surface that protects
the display from abrasion.
Note: The tablet PC is not waterproof. Do not pour liquids on the system or wash it
with a wet cloth.
To install a new screen protector:
1. If a screen protector is already installed on the display screen, remove it before in-
stalling the new screen protector. The screen protector is held onto the display screen
surface by a thin strip of adhesive around the edges. A notch in one corner of the
screen protector allows you to slide your ngernail under the screen protector for easy
removal.
2. Clean the display by wiping the screen surface gently using a so cotton cloth damp-
ened with denatured alcohol. Ensure that all residues have been removed from the
screen before applying a new screen protector.
3. Remove the protective coating from the adhesive side of the screen protector rst.
Apply the screen protector to the display screen surface. When doing so, orient the
screen protector with the adhesive side of the screen protector facing the display
screen and the notched corner of the screen protector toward the lower le corner
of the display screen.
4. Apply pressure to the screen protector with your nger using a continuous wiping
motion along the edges. The adhesive sets completely within 48 hours. To ensure a
good seal between the screen protector and the display, do not li the screen protector
from the display once it has been applied.
5. Remove the protective plastic cover from the face of the screen protector.
6. Clean any residue remaining on the screen protector by wiping gently with a so cot-
ton cloth dampened with denatured alcohol. Wipe the screen protector with a so dry
cloth to remove any low-tack adhesive.