Name: TestEquity F4T
Brand: TestEquity
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Chapter 3 – Communications

TestEquity F4T Controller Page 17

F4 Compatibility Mode (Data Map 3)

The following common registers are available in the F4 Compatibility Mode (Data Map 3). This

will allow you to use software that was written for the original F4 Controller. Only a limited set

of parameters are available in this compatibility mode, but it should be sufficient for most

applications. This register list is only valid for Firmware Revision 03:06:0011, released May 5,

2017 and higher. Older firmware revisions do not have an F4 Compatibility Mode for controllers

with Cascade Control.

Parameter Name Register Data Type and Access (Read or Write)

Temperature Set Point 300 16-bit Signed RW

Air Temperature 100 16-bit Signed R

Air Temp Input Precision 606 16-bit Signed RW 0 (0), 0.0 (1), 0.00 (2), 0.000 (3)

Part Temperature 108 16-bit Signed RW

Part Temp Input Precision 626 16-bit Signed RW 0 (0), 0.0 (1), 0.00 (2), 0.000 (3)

°C or °F 901 16-bit Signed RW °C (1), °F (0)

Air Temp Input Error 101 16-bit R No Error = 0, Error = 1

Part Temp Input Error 109 16-bit R No Error = 0, Error = 1

Event 1 2000 16-bit RW Off = 0, On = 1

Event 2 2010 16-bit RW Off = 0, On = 1

Event 3 2020 16-bit RW Off = 0, On = 1

Event 4 2030 16-bit RW Off = 0, On = 1

Event 5 2040 16-bit RW Off = 0, On = 1

Event 6 2050 16-bit RW Off = 0, On = 1

Event 7 2060 16-bit RW Off = 0, On = 1

Profile Action:

Resume Profile 1209 16-bit R

Hold Profile 1210 16-bit W

Terminate Profile 1217 16-bit W

Profile Start:

Profile Start File # 4000 16-bit W

Profile Start Step # 4001 16-bit W

Profile Action Start: 4002 16-bit W Create (1)

Insert Step (2)

Delete Current profile (3)

Delete Step (4)

Start Profile (5)

Delete all Profiles (256)

TestEquity F4T Addendum

Other manuals for TestEquity F4T