Chapter 4 – Retransmit Option TE-F4T-RETRANSMIT
TestEquity F4T Controller Page 23
Chapter 4 – Retransmit Option TE-F4T-RETRANSMIT
Introduction
The Retransmit option provides three analog outputs which can be used to drive an analog
recorder. This option deletes the Alarm Outputs.
Connections
Connections to the Retransmit terminals are on the back of the F4T controller. You will have to
open the chamber’s electrical system to access these terminals.
Air Temperature Retransmit
Slot 3, Terminals F1 (–), H1 (+)
Part Temperature Retransmit
Slot 3, Terminals F2 (–), H2 (+)
Temperature Set Point Retransmit
Slot 3, Terminals F3 (–), H3 (+)
The scaling is set by TestEquity for 0 to 5VDC = –100°C to +200°C. The scaling can be changed
in the Settings>Outputs menu. You must to be logged in as an “Admin” to change these settings.
Please contact TestEquity for the “Admin” password in order to have access to these settings.
Select the desired Retransmit Output…
Scroll down to see all the settings…
To Previous Page
Loading...
