ii
Warnings and cautions
1. The specimen supporting base freely drops. Never enter the tester base, otherwise an accident may result.
2. A specimen may tilt down in an unexpected direction due to drop collision. Particularly be careful since certain
specimens may be broken to scatter.
3. Make sure at all times that none of other workers, packaged cargoes, and other material exists around the base.
4. If the other tester exists nearby, don’t disturb mutual work with due care by calling out to each other.
5. Set each specimen at the specified position on the specimen fixing base without fail and use the equipment
within the rated weight range.
6. Don’t process any noxious chemicals around the tester, otherwise a color change of paint or a trouble may occur.
7. Turn off the power switch if smoke goes up, an offensive smell gives out, or other abnormal symptom occurred,
or if water or the like was introduced into the tester or control unit. Don’t use the equipment as it is, otherwise
a fire or an electric shock accident may occur.
8. Don’t remove any parts of the main unit or disconnect the control unit from the case during test, otherwise it
may cause ingress of foreign substances to result in a trouble. It is possible that parts are replaced and checked
due to unavoidable circumstances during repair of a trouble.
In such a case, never perform any work other than specified by our instruction contents. If a foreign
substance should have introduced into the tester, turn off the power switch and contact us. Don’t continue
the work as it is, otherwise a trouble or an electric shock accident may occur.
9. Never modify the equipment, otherwise a fire, an electric accident, or a trouble may occur.
10. Don’t put any heavy package on the power cord of the control unit nor pull, forcibly bend, or scratch it,
otherwise a fire or an electric shock accident may result.
11. For relocating the equipment, contact us and observe our instructions.
If the hoisting position or work procedures for moving the equipment are wrong, the tester and control unit
may be damaged. Don’t ride on the tester or control unit nor put any heavy package on them, otherwise the
package may drop or break to cause injuries.
If the tester or control unit should have been damaged, please contact us.
12. It is recommended to execute “periodical maintenance check (check and repair)″ once every year. Contact
us.
To Next Page
Loading...
