TESTO 270 BT - Carrying out Configuration on the Device; Quitting Configuration Mode Early and Saving

6 First steps
16
6.5.2 Carrying out configuration on the device
Critical settings can be protected by PIN via the testo Smart App.
✓
Requirement: The instrument is switched off.
Switch the instrument on
1
Hold [Hold] down and press [ ].
Automatically switch the instrument off

Auto-off and on or off light up in the display.
2
Switch Auto-off on or off: [ ] or [ ] and confirm with [Hold].
Set the temperature unit

°C or °F lights up in the display.
3
Set the temperature unit (°C/°F): [ ] or [ ] and confirm with [Hold].
Switch on/off Bluetooth

Bluetooth and on or off light up in the display
4
Switch Bluetooth on or off: [ ] or [ ] and confirm with [Hold].
6.5.3 Quitting configuration mode early and
saving
You can quit the configuration mode early.
The configuration mode cannot be stopped in the adjustment /
calibration process.
1
Quit configuration mode early: Press and hold [ ] for approx. 1 sec.

Configuration mode is stopped.
The values which have so far been set and confirmed with [Hold] are
applied.
The instrument switches to the measuring mode.