TESTO 270 BT - Cleaning the Sensor

9 Maintaining the product
28
- 000 lights up on the display,
the instrument is ready for use.
7
If necessary, switch instrument off.
When not in use for a long period: Take out the batteries.
9.2 Cleaning the sensor
WARNING
Risk of burns due to hot instrument parts (sensor and probe
shaft)!
- Do not touch hot instrument parts with your hands.
- Allow instrument to cool sufficiently before cleaning.
- In the event of burns, immediately cool corresponding spot
with cold water and see a doctor if necessary.
CAUTION
Possible damage to the sensor!
- Do not remove cold oil residues from the sensor.
- Do not use any sharp-edged objects.
- Do not use aggressive cleaning agents and solvents.
Improper handling
- Do not use force!
1
Gently clean sensor with a soft paper towel, or rinse under running
water.
Do not use any aggressive cleaning agents or solvents! Mild household
cleaning agents and soap suds may be used.
2
Carefully dry sensor with a soft paper towel.
With cold oil residues on the sensor
1
Immerse sensor in hot oil.
2
Allow sensor and probe shaft to cool until there is no longer a risk of
burns.
3
Clean sensor before the oil residues cool down.