8 Maintaining the product
43
this, a stroboscope flash can be triggered at the desired position
even with fluctuating rotational speeds or when the system is
starting up.
DIV (pulse divider)
This function is only active with an external trigger signal. A value x
can be set with the pulse divider. The external trigger signal is then
divided by this value.
Example: An external trigger (e.g. rotational speed sensor) that
scans a gear wheel provides a signal with every tooth. With DIV
value = 10, a flash is only triggered with every 10th signal.
OPT
Edge selection of the trigger signal. 0 = positive edge , 1 = negative
edge. With this option, the polarity of the trigger signal can be
defined.
Pos: 36 /TD/Überschr iften/7. Produkt ins tand halten @ 0\mod_1173789 831362_79.doc @ 397 @ 1
8 Maintaining the product
Pos: 37 /TD/Produkt ins tand halten/testo 477/ Batterien wechseln @ 4\ mod_1249038428877_79. doc @ 46791 @ 2
8.1. Changing batteries/rechargeable batteries
Only operate and store instrument with battery
compartment cover.
If the instrument is not used for a longer period, remove all
batteries/rechargeable batteries from the instrument.
Incompletely charged batteries/rechargeable batteries
reduce the operating time.
1. Loosen screws on the bottom of the instrument.
2 Remove battery compartment cover.
3. Remove batteries/rechargeable batteries.
4. Insert new batteries (AA)/charged NiMH rechargeable batteries
(AA) (observe the polarity!)
5. Close the battery compartment cover.
6. Tighten screws.
Pos: 38 /TD/Produkt ins tand halten/Gerät r einigen @ 0\mod_11800834465 79_79.doc @ 1748 @ 5
Cleaning the instrument
> If the housing of the instrument is dirty, clean it with a damp
cloth.
Do not use any aggressive cleaning agents or solvents! Weak
household cleaning agents and soap suds may be used.
To Next Page
Loading...
