TESTO 622 - Basic Properties; First Steps; Removing Protective Film; Inserting Batteries

5 First steps
29
4.2. Basic properties
Pos: 23 /TD/Produk tbeschreibung/ Grundlegende Eigenschaf ten/testo 622/test o 622 Stromversorgun g @ 3\mod_1233922706909_7 9.doc @ 23763 @ 5
Power supply
The instrument is powered optionally by:
• 4 batteries / rechargeable batteries, type AA
Pos: 24 /TD/Produk tbeschreibung/ Grundlegende Eigenschaf ten/testo 622/test o 622 Wandmontage @ 4\mod_12 54468245886_79.doc @ 50984 @ 5
Wall mounting
The distance between the upper and lower drill hole is 63 mm.
Pos: 25 /TD/Übersc hriften/5. Erste Sc hritte @ 0\mod_1173774895 039_79.doc @ 319 @ 1
5 First steps
Pos: 26 /TD/Erst e Schritte/testo 622/te sto 622 Schutzfolie en tfernen @ 3\mod_123392796 5698_79.doc @ 23802 @ 5
Removing the protective film
> Remove the protective film from the display
Pos: 27 /TD/Erst e Schritte/testo 622/te sto 622 Batterie ei nlegen @ 3\mod_12339273720 10_79.doc @ 23783 @ 5
Inserting batteries/rechargeable batteries
1. Open the battery compartment on the rear of the instrument.
2. Insert batteries/rechargeable batteries (observe the polarity!)
3. Close the battery compartment.
Pos: 28 /TD/Übersc hriften/6. Produkt verwenden @ 0\mod_11737749 28554_79.doc @ 328 @ 1